Furuno FA-170 - Unit Interconnection

2. WIRING
2-4
2.3 Unit Interconnection
The transponder unit (FA-1701), monitor unit (FA-1702) and the pilot plug unit (FA-
1703) use different connectors for interconnection. See the figures below to fabricate
the connections.
How to attach wires to the connectors
Monitor unit FA-1702
Terminal opener is located inside cable clamp (rear cover).
Transponder unit FA-1701
Terminal opener is located on rear of the FA-1701 cover.
Procedure
1. Twist the cores.
2. Push the terminal opener downward.
3. Insert the wire to hole.
4. Remove the terminal opener.
5. Pull the wire to confirm that it is secure.
Terminal
opener
PushPush
Procedure
1. Twist core.
2. Insert terminal opener and push.
3. Insert wire into hole. Be careful not to pinch the sheath.
4. Release terminal opener.
5. Pull wire to confirm it is correctly inserted.
Pilot plug unit FA-1703
Use a flat head screwdriver to open the terminals.
Procedure
1. Twist core.
2. Using a flat screw driver, push the terminal opener.
3. Insert wire into hole. Be careful not to pinch the sheath.
4. Release terminal opener.
5. Pull wire to confirm it is correctly inserted.
Push downward.
Terminal opener
WAGO connector
Wire
Twist
WAGO connector
SATO PARTS connector
Wire
Twist
Push downward.
Wire
Twist