12
Route planning
1. Put the arrow on Route in the information area, and then click the Plan
button to open the Plan Route dialog box with Route Plan menu. Select
Create and push the scrollwheel.
2. Spin the scrollwheel to choose character, and then push the scrollwheel. Repeat to
enter name desired and then click the OK button.
3. Check "Enable changes" in the Plan Route dialog box. Choose
position of a waypoint by placing the arrow on the location
desired on the electronic chart display and then pushing the left
mouse button. After entering a waypoint, edit Name, Steering
mode, Radius, Channel limit and Speed (Min, Max) as
appropriate in the Plan Route dialog box.
4. Open the Alarms page to define safety contour and other specified
conditions for checking the route. Choose item from a list and then
click Indication (to get a visual indication), Alarm (to get the
audible alarm) or Ignore (to remove check item) button as
appropriate.
5. Open the Check page to detect areas where depth is less than the
safety contour or where specified conditions exist. The chart radar
can examine chart database against planned route to make a list
of alarms where a route crosses a safety contour or specified
areas used in chart alarms.
6. Open the Parameter page to enter Estimated Time of Departure
(ETD) and Estimated Time of Arrival (ETA), if you are using Time
table optimizing. Choose desired optimizing mode from the
Optimize window.
1. Spin the scrollwheel to show Symbol Display/Info/ in the guidance box and left-click to show
the Symbol Display dialog box.
2. Right click to show the Route page.
3. Check or uncheck required item (Center line, Channel limit, Leg marks, etc.).
Creating a new route
Displaying planned route
[ Route Plan ]
Select
Unselect
Create
Exchange with Monitored
Copy from Monitored
Backup and Restore
Report
Full WPT Report
Passage Plan Report
Close
Select Route
Monitor

Plan

X
DISP
DISP
WPT
WPT
OK
Alerts
Alerts
Alerts:
Alerts:
Planned Notes
Legs by alert
Alerts by leg
Alerts: 12
To Next Page
Loading...
