3-1
3. INITIAL SETTINGS
This section provides the information necessary for initial setup of the equipment. First turn on
the power and set display language. For the FCV-1200L, enter transducer used, by model
number (FURUNO transducer only) or by specifications. For either model, execute other
procedures as applicable.
3.1 Language Setting
1. Turn on the power. The following display appears.
Note:
The picture on your set may be turned 90
°
. Picture orientation may be corrected at
section 3.2.
Please set language.
([ / ]: Select, [+]: Enter)
XXXXXXXX
XXXXXXXX
English
XXXXX
(For Japanese customers)
(Japanese)
Figure 3-1 Initial display screen
2. Press [ ] to select English, and then press the [+] key to set. The following display appears
on the FCV-1200L only.
Carrry out transducer setting.
Press any key to go to Transducer setting menu.
3.
FCV-1200L:
Change picture orientation (if necessary) and set transducer type. Then, go to
applicable section(s).
FCV-1200LM:
Change picture orientation (if necessary) and turn off the power. Go to section
3.4 and follow the appropriate procedure according to equipment connected (transceiver unit,
external video sounder, picture recorder, telesounder). Then, go to other applicable sections.
To Next Page
Loading...
