3-20
3.10 Demonstration Mode
The demonstration mode provides a simulated video sounder picture. Connection of the
transducer is not necessary. All controls are operational.
1. Turn on the power while pressing any key to display the installation main menu.
2. Press [+] to select DEMO.
XDCR SETTING INSTALLATION DEMO
DEMO MODE : OFF
[-/+]: Change setting, Turn OFF to exit
Figure 3-13 DEMO menu
3. Press [
] to select DEMO MODE, and then press [+] to open the dialog box.
OFF ON
4. Use [+] or [-] to select ON or OFF (default setting) as appropriate, and then press [
] or [ ]
to close the dialog box.
5. Turn off the power.
6. Turn on the power. “<DEMO>” appears at the bottom of the screen when the demonstration
mode is on.
To Next Page
Loading...
