Furuno FCV-295 - 1.2 Power On;Off; 1.3 Adjusting Display Brilliance; 1.4 Selecting a Display

1. OPERATION
2
1.2 Power On/Off
Press the [ /BRILL] key to turn on the pow-
er. The unit beeps, the startup screen ap-
pears and then the last-used display is
shown.
To turn off the power, press the [ /BRILL]
key more than three seconds. The time re-
maining until power off is counted down on
the screen.
1.3 Adjusting Display
Brilliance
1. With the equipment powered, press the
[ /BRILL] key momentarily to show the
brilliance adjustment window.
2. Press the [ /BRILL] key to adjust bril-
liance. Continuous pressing changes the
brilliance cyclically.
(0→1→...→9→8→...→0→1→...). "0" is
the lowest and "9" is the highest.
You can also use W or X for the adjust-
ment.
3. Press the [ENTER] or [MENU/ESC] key
to save the setting and close the window.
(The window is automatically closed if the
brilliance is not adjusted within approx.
six seconds.)
Note: When the power is reapplied after turn-
ing off the equipment with minimum brilliance,
minimum brilliance will be set after the equip-
ment goes through its initial start up. (The
start up screen appears with the maximum
brilliance.) Adjust the brilliance as necessary.
1.4 Selecting a Display
The FCV-295 has seven display modes: low
frequency display, high frequency display,
dual frequency display, low frequency+zoom,
high frequency+zoom, user 1 display, and
user 2 display. Select one with the [MODE]
control as follows:
1. Rotate the [MODE] control to open the
mode selection window.
2. Rotate the [MODE] control to select a dis-
play.
1.4.1 Single frequency display
Low frequency
The lower the frequency of the ultrasonic sig-
nal, the wider the detection area. Therefore,
the low frequency is useful for general detec-
tion and judging bottom condition.
High frequency
The higher the frequency of the ultrasonic sig-
nal, the better the resolution. For this reason
the high frequency is ideal for detailed obser-
vation of fish schools.
Beamwidth
Program No. 0252365-XX.XX
Dual (LF/HF)
( ): Mode indication at the top of the screen
BL: Bottom Lock LF: Low Frequency
BZ: Bottom Zoom HF: High Frequency
MZ: Marker Zoom BD: Bottom Discrimination
LOW frequency zoom mode
(BL-LF, BZ-LF, MZ-LF, BD-LF)
Low frequency single mode (LF)
High frequency single mode (HF)
High frequency zoom mode
(BL-HF, BZ-HF, MZ-HF, BD-HF)
User 1, 2
Low
frequency
High
frequency