6. WEB FUNCTIONS
6-30
Entry screen/Edit screen
DST. address Show the recipient address (if not set, “anywhere” is shown).
From address Show the sender address (if not set, “anywhere” is shown).
Protocol Display the protocol.
Area • If [Protocol] is [Any], displays the protocol number.
• If [Protocol] is [TCP/UDP]: displays the port range.
• If [Protocol] is [TCP], [UDP]: displays the port range or port
numbers for [Dst.] and [From].
Edit button Edit the IP filter, on the edit screen.
Item Description
Session Display session name.
Action Select action (Ignore, Reject, Pass). Select [Pass] to set [TCP/
UDP(NAPT)] in [Protocol].
Direction Show direction (WAN→LAN, LAN→WAN). Select [WAN→LAN]
to set [TCP/UDP(NAPT)] in [Protocol].
DST. address Enter, edit destination address (IPv4 address).
From address Enter, edit source address (IPv4 address).
Protocol Select protocol (ALL, ICMP, Any, TCP/UDP, TCP/UDP(NAPT)).
• Select protocol (ALL, ICMP, Any, TCP/UDP).
• If [Protocol] is [Any], enter the protocol number (1-255).
• If [Protocol] is [TCP/UDP] only, select TCP/UDP, TCP, UDP
from list box. Enter port no. (range: 1-65535).
• If [Protocol] is [TCP/UDP(NAPT)] only, select TCP or UDP,
and enter the port numbers for [Dst.] and [From] (range: 1-
65535).
Add button Register entered information. The IP filter setting screen ap-
pears.
Save button Save entered information. The IP filter setting screen appears.
Cancel button Restore previous settings and return to the IP filter setting
screen.
Item Description
Entry screen Edit screen
To Next Page
Loading...
Need help?
General
