2.Basic Operation
8
2.3 Call Channel Programming
Call channel is used to select Channel 9 (default), however,
you can program the call channel with your most often-used
channels in each channel group for quick recall.
q While pushing [
HI/LO
], push [
CH/WX
]( ) one or
more times to select the desired channel group (U.S.A., In-
ternational, Canada) to be programmed.
w Push [
16
]( ) for 1 sec. to select call channel of the se-
lected channel group.
•“CALL” and call channel number appear.
• The order of indication precedence is “SP OFF,” “LOCAL” and
“CALL.”
e
Push
[
16
]( )
again for 3
sec. (until a long beep
changes to 2 short beeps)
to enter call channel pro-
gramming condition.
• Channel number starts blinking.
r Rotate [
CHANNEL
] to se-
lect the desired channel.
t Push [
16
]( ) to program
the displayed channel as
call channel.
• Push [
CH/WX
]( ) to cancel.
• The channel number stops blinking.
2.4 Channel Comments
Memory channels can be tagged with alphanumeric com-
ments of up to 10 characters each.
Capital letters, small letters, numerals, some symbols (! " #
$ % & ' ( ) * + , - ./ =) and space can be used.
q Select the desired channel.
• Cancel dualwatch, Tri-watch or scan in advance.
w While pushing [
HI/LO
], push [
16
]( ) to edit the channel
comment.
• A cursor appears and blinks.
e Select the desired character by rotating [
CHANNEL
] or by
pushing [
YY
]
/
[
ZZ
] on the microphone.
• Push [
CH/WX
] or [
SCAN
] to move the cursor forward or back-
ward, respectively.
r Push [
16
]( ) to input and set the comment.
• Push [
HI/LO
] to cancel.
• The cursor disappears.
t Repeat steps q to r to program the other channels, if de-
sired.
9
To Next Page
Loading...
