Beep tone
Beep
Scan mode
Scan Mode
Weather alert
WX Alert
Scan resume timer
Scan Timer
Attenuation level
Attenuation
Level
Internal speaker
Internal
Speaker
Scrambler code*
Scrambler
Code
Dual/tri watch
DUAL/TRI
DSC watch
DSCWatch
LCD contrast
LCD
Contrast
Automatic acknowledgement
AUTO ACK
Push
*
Scrambeler code is available only
when FM-3030 is installed.
Push when using FM-3010
DSC Watch, Internal Speaker
and AUTO ACK items are not selectable
when using FM-3010.
7.1 Set Mode Programming
Set mode is used to change the conditions of the trans-
ceiver’s functions: scan mode (Normal or Priority), scan re-
sume timer, weather alert, Dualwatch/Tri-watch selection,
DSC watch, transceiver’s beep tone (transceiver or FM-
3010), internal speaker, LCD contrast (transceiver or FM-
3010), RF attenuation level, scrambler code and automatic
acknowledgement.
q Turn power OFF.
w While pushing [
16
]( ), turn power ON to enter Set mode.
e After the display appears, release [
16
]( ).
r Push [
16
]( ) to select the desired item.
Or push [
16
]( ) on the FM-3010 to select the item when
using an optional FM-3010.
t Rotate [
CHANNEL
] to select the desired condition of the
item. Use [
YY
]
/
[
ZZ
] when using an optional FM-3010.
y Turn power OFF, then turn ON again to exit Set mode
9
9
9
9
• SET MODE CONSTRUCTION
1. Available functions may differ depending on dealer set-
ting.
2. The optional FM-3010 has it’s own settings for the beep
tone and LCD contrast.
To Next Page
Loading...
