Furuno FM-3000 - Transmitting DSC Calls

20
5.DSC Operation
5.6 Transmitting DSC Calls
5.6.1 Transmitting Individual call
The Individual call function allows you to transmit a DSC sig-
nal to a specific ship only.
q Push [
DSC/ENT
] to enter the DSC menu.
w Rotate [
CHANNEL
] to select “Individual,” push
[
DSC/ENT
].
e
Rotate [
CHANNEL
] to select the desired pre-programmed
individual address or “Manual Input,” push
[
DSC/ENT
] .
• The ID code for the Individual call can be set in advance. (p. 13)
•When “Manual Input” is selected, set the 9-digit ID code
(1st digit must not be ‘0’) for the individual you wish to call by
using [
CHANNEL
].
-Push [
CH/WX
] or [
SCAN
] for cursor movement.
- After 9-digit is input, push [
DSC/ENT
] to set the ID code.
r Rotate [
CHANNEL
] to select a desired intership channel
or “Manual Input,” push [
DSC/ENT
].
•When “Manual Input” is selected, rotate [
CHANNEL
] to se-
lect the desired channel other than Channel 70, push [
DSC/ENT
] .
t Push [
DSC/ENT
] to transmit the Individual call.
• If Channel 70 is busy, the transceiver stands by until the channel
becomes clear.
ToCall,
ToCancel
[other]
[DSC/ENT]
Individual
ToCancel
[other]
Ch70isBUSY
Push [DSC/ENT] to transmit DSC call.
When Ch 70 is busy.
SelChannel
69
˘08
77
SelAddress
Ricky
ManualSet
˘Tom
˘Individual
POSInput
Group
SelItem