13
5. DSC Operation
5.1 MMSI Code Programming
The 9-digit MMSI (Maritime Mobile Service Identity: DSC self
ID) code can be programmed at power ON.
Note: This function is not available when the MMSI code has
been programmed by the dealer. This code programming can
be performed only twice.
q Turn power OFF.
w While pushing [
DSC/ENT
], turn power ON to enter MMSI
code programming condition.
e After the display appears, release [
DSC/ENT
].
r Edit the specific MMSI code by rotating [
CHANNEL
].
• Push [
CH/WX
] or [
SCAN
] to move the cursor forward or back-
ward, respectively.
t Input the 9 digit codes, then push [
DSC/ENT
] to set the
code.
• Returns to the normal operation.
5.2 DSC Individual ID
A total of 40 DSC address IDs can be programmed and
named with up to 10 characters.
DD
Programming Address ID/Group ID
q Push [
DSC/ENT
] to enter the DSC menu.
w Rotate [
CHANNEL
] to select “Set up,” push
[
DSC/ENT
].
e
Rotate
[
CHANNEL
]
to select “Add ID,” push
[
DSC/ENT
]
.
To Next Page
Loading...
