44
8.Connections and Maintenance
8.5.2 Using the optional FM-3040
An optional FM-3040 FLUSH MOUNT is available for mounting
the transceiver to a flat surface such as an instrument panel.
q Using the template on the last page, carefully cut a hole
into the instrument panel (or wherever you plan to mount
the transceiver).
w Slide the transceiver through the hole as shown below.
e Attach the 2 supplied bolts (M5 × 8 mm) on either side of
the FM-3000.
r Attach the clamps on either side of the FM-3000.
• Make sure that the clamps align parallel to the FM-3000’s body.
t Tighten the end bolts on the clamps (rotate clockwise) so
that the clamps press firmly against the inside of the in-
strument control panel.
y Tighten the locking nuts (rotate counterclockwise) so that
the FM-3000 is securely mounted in position as below.
u Connect the antenna and power cable, then return the in-
strument control panel to its original place.
KEEP the transceiver and microphone at least 1
meter away from your vessel’s magnetic navigation
compass.
RR
CAUTION
To Next Page
Loading...
