3.3 DSC SETUP
3-22
Note 2) When the registered message file is send.
1. Press [*FILE] key. The “Send message file” display appears.
2. Select the file and then press [CALL]. The message is automatically send. When
editing the message, press [ENT]. The popup below appears. Select “DETAIL” and
then press [ENT].
After editing the registered message, press [CALL] to sent.
Note 3) When the registered message file is deleted individually.
1. Press [*FILE] key. The “Send message file” display appears.
2. Select the file you want to delete and then press [ENT]. The popup below appears.
Select “DELETE” and the press [ENT]. The registered message is deleted from the
list.
To Next Page
Loading...
