5. INITIAL SETTINGS
16
Setting DATA 4 to “COM.” (general data)
Waypoints and Routes data can be received from a personal computer, through the DATA
4 port.
1) Press [MENU], [9] and [5].
2) Press
!
or
"
to select DATA4. Level.
3) Press
#
or
$
to select level of personal computer; RS232C or RS422.
4) Press the [ENT] key.
5) Press
$
to select Com.
6) Press
"
to select To Next Page. The DATA 4 I/O SETUP <Com.> menu appears.
To Previous Page
Baud Rate 9600 bps
L WPT
Command Stop Start
Save Data WPT/RTE
Command Stop Start
DATA 4 I/O SETUP <Com.> 2/2
MENU : Escape
ENT : Enter
: Select
Load Data
WPT/RTE
Figure 5-7 DATA 4 I/O SETUP <Com.> menu
7) Press
!
or
"
to select Baud Rate.
8) Press
#
or
$
to select baud rate; 4800bps, 9600bps or 19200bps.
9) Press the [ENT] key.
10) Press
#
or
$
to select WPT/RTE.
11) Press
"
to select Command. Stop, on the same line as Command, appears in reverse
video.
12) Press
$
to select Start. The message shown in Figure 5-8 appears.
Loading erases current data
and stops Route navigation
Are you sure to load?
ENT: Yes MENU: No
Figure 5-8
13) Press the [ENT] key. The message shown in Figure 5-9 appears while data is being
loaded.
Now loading
Waypoint/Route data !
MENU: Stop
Figure 5-9
To Next Page
Loading...
