5. INITIAL SETTINGS
17
14) Output data from the computer. When loading data is completed, the cursor shifts to
Stop.
15) Press the [ESC] key.
Setting DATA 4 to DGPS
An external DGPS receiver can be connected to the DATA 4 port.
Follow the procedure below to setup the GP-90 according to the specifications of the DGPS
receiver.
1) Press [MENU], [9] and [5].
2) Press
!
or
"
to select Level.
3) Press
#
or
$
to select level; RS232C or RS422.
4) Press the [ENT] key.
5) Press
#
or
$
to select DGPS.
6) Press
"
to select To Next Page.
DATA 4 I/O SETUP <DGPS> 2/2
To previous Page
First Bit
Parity
Stop Bit
Baud Rate
: Select
ENT: Enter MENU: Escape
MSB LSB
EVEN ODD NONE
12
4800 9600
Figure 5-10 DATA 4 I/O SETUP <DGPS> menu
7) Press
!
or
"
to select First Bit.
8) Press
#
or
$
select first bit; MSB or LSB.
9) Press
"
to select Parity.
10) Press
#
or
$
to select parity bit; EVEN, ODD or NONE.
11) Press
"
to select Stop Bit.
12) Press
#
or
$
to select stop bit; 1 or 2.
13) Press
"
to select Baud Rate.
14) Press
#
or
$
to select baud rate; 4800 or 9600.
15) Press the [ENT] key.
16) Press the [ESC] key.
To Next Page
Loading...
