8
Main mark Sub mark Item Function
Auto adjustment* Adjusts image timing automatically.
Pixel adjustment*
Adjusts the number of pixels in the horizontal
direction. If there is pixel count mismatch
between analog signal and monitor, vertical
flicker and unclear text will result.
After selecting the item, adjust the image on the
bar.
To the left (◄) ↔ To the right (►)
Phase adjustment*
Adjusts the timing of sampling so that the flicker
disappears and the text is clear.
fter selecting the item, adjust the phase on the
bar.
To the left (◄) ↔ To the right (►)
Horizontal position
adjustment*
Adjusts the image position horizontally.
After selecting the item, adjust the horizontal
position on the
bar.
To the left (◄) ↔ To the right (►)
Position,
Phase
Vertical position
adjustment*
Adjusts the image position vertically.
After selecting the item, adjust the vertical
position on the
bar.
Down (◄) ↔ Up (►)
Setting of OSD
time out
Sets the OSD time out. (Time to wait to blank
screen without key operation.)
After selecting the item, choose the time out of
four.
5 sec. 15 sec.
30 sec.
60 sec.
OSD
position
OSD location
Sets the OSD location on the screen.
After selecting the item, choose the location out
of five.
Center
Bottom
Left
Top
Right
*: When inputting DVI, these marks are not shown.
To Next Page
Loading...
