Furuno MU-201C - Page 16

9
Contents of other marks and messages
Mark/Message Function
Select the mark and press [▼] to save the ongoing setting or the auto
adjustment value. Then, OSD is off.
Select the mark and press [▼] to cancel the ongoing setting or the auto
adjustment. Then, OSD is off.
When phase adjustment is completed, this mark is shown. (Press [▼]
to erase this mark.)
This message shows no signal is input.
This message shows the input resolution signal is beyond the
specification of the MU-201C.
This message shows the input video signal is beyond the specification
of the MU-201C.