17
3.1 Setup for Single MFD in the Network
When you have an MFD in the network, do the following procedures.
Language, DHCP server setting
1. Press the power switch on the control unit to power the system. In a few minutes, the Installa-
tion Wizard starts, showing the display below. The system counts the number of sounders,
radars and other sensors you have connected and displays the results. Allow the system to
count the number of sensors, which takes about 30 seconds. Do not click the Skip button.
2. After the system has confirmed sensors, the language selection screen appears. The default
language is English. If you don’t need to change the language, rotate the rotary knob to select
the Next button and then push the knob. If necessary, change language: choose the Select
Language pull-down menu, and push the left-click button. Note that the language of the Instal-
lation Wizard is English regardless of language setting.
To Next Page
Loading...
Need help?
General