2. STEERING MODES
2-33
How to set the safe helm mode
1. Open the menu in the STBY mode.
2. Use the Course control knob to select the [OTHER] menu then select [SAFE
HELM/P.ASSIST SETUP].
3. Use the Course control knob to select [SAFE HELM] then push the knob.
4. Use the Course control knob to select [ON] then push the knob.
5. Use the Course control knob to select [RETURN DELAY] then push the knob.
6. Rotate the Course control knob to set the return delay, the amount of time that
elapses before the safe helm mode is deactivated and the AUTO or NAV mode is
restored. The setting range is 1-20 seconds.
7. Use the Course control knob to select [SAFE HELM RESPONSE] then push the
knob.
8. Turn the Course control knob to set the response then push the knob. Turn the
helm to port or starboard. A beep sounds and the indication PORT or STBD on
the menu appear in reverse video.
9. Press the MENU key to finish.
SAFE HELM/P.ASSIST SETUP
SAFE HELM: ON
RETURN DELAY 5 SEC
SAFE HELM RESPONSE
POWER ASSIST: OFF
SAFE HELM RESPONSE
RESPONSE: 6 PORT STBD
TURN HELM PORT/STBD TO
SET SAFE HELM RESPONSE
TIME. HIGHER VALUE =
FASTER RESPONSE
PUSH MENU KEY TO CONTINUE
To Next Page
Loading...
