5. MAINTENANCE, TROUBLESHOOTING
5-3
5.3.2 Processor unit test
This test checks the processor unit for correct operation. Open the diagnostic test op-
tions window, select [PROCESSOR UNIT] then push the Course control knob. The
results for the ROM, RAM and RUDDER ANGLE are shown as OK or NG. If NG ap-
pears, repeat the test. If the error condition continues, contact your dealer.
[ROM]: "OK" for normal, program number[RAM]: "OK" for normal, program num-
ber[BACKUP]: Backup data test, "OK" for normal.[RUDDER ANGLE]: "OK" for nor-
mal, actual rudder angle.[BYPASS/CLUTCH]: Bypass/clutch amperage. ("NOT
PRESENT" shown in case of no connection.)[RC1/RC2]: Remote controller state (ON
or OFF) and rudder signal input value. "NOT USED" shown in case of no connec-
tion.[INPUT VOLTAGE]: Voltage. [PORT1/PORT2/CAN]: I/O test for PORT1/PORT2/
CAN (CAN bus). OK for normal. [CAN ID]: ID of CAN bus equipment.
5.3.3 Control unit test
This test checks the control unit for correct operation. Open the diagnostic test options
window, select [CONTROL UNIT] then push the Course control knob. The results for
[ROM], [RAM], [BACKUP], and [COMMUNICATION] are shown as OK or NG (No
Good). If NG appears, repeat the test. If the error condition continues, contact your
dealer.
ROM: OK 6454007-**.**
6454009-**.**
RAM: OK BACKUP: OK
RUDDER ANGLE: OK 0°
BYPASS/CLUTCH: 0.7A
RC1/RC2: OFF -1° /OFF -2°
INPUT VOLTAGE: 24.5 V
PORT1/PORT2/CAN: - -/- -/OK
CAN ID: 39713 CPU/PWR: */*
PROCESSOR UNIT ID: 39768
*: Version no.
**.**: Program version no.
ROM: OK 6454011-**.**
6454010-**.**
RAM: OK BACKUP: OK
COMMUNICATION: OK
CONTROLLER ID: 2
CAN ID: 0 CPU:*
CONTROL UNIT
*: Version no.
**.**: Program version no.
To Next Page
Loading...
