4. HOW TO CUSTOMIZE YOUR NAVPILOT
4-8
5. Rotate the Course control knob to select [SOURCE1] then push the knob.
If you have some equipment which outputs nav data, the name appears in the win-
dow. In the example above, a NavNet3 equipment, with unique number of
000C2F, is connected.
6. Rotate the Course control knob to select source then push the knob. If you have
more than one device that outputs nav data, you can select it at [SOURCE2].
Note: If you have NavNet vx2 equipment connected and it is synchronized with the
NAVpilot ([NAVNET2] turned on in the [AUTO OPTION] menu, [SOURCE2] is auto-
matically selected.
4.5 NavNet vx2 Synchronization
The NAVpilot goes to the NAV mode when it receives a P sentence (proprietary FU-
RUNO sentence) from a NavNet vx2 equipment. For example, “autopilot information”.
You can turn this feature on or off as follows:
1. Open the [OTHER MENU] followed by the [NAV OPTION] menu.
2. Rotate the Course control knob to select [NAVNET2] then push the knob.
3. Rotate the Course control knob to select [OFF] or [ON].
4. Push the Course control knob to finish.
- - - - - - - - - - - - - -
NAVNET3: 000C2F
PORT2
ON
OFF
To Next Page
Loading...
