4. HOW TO CUSTOMIZE YOUR NAVPILOT
4-7
4.3 Course After Operation of a Remote Controller
Select the course to follow after a remote controller is operated.
1. Open the [OTHER MENU] followed by the [AUTO OPTION] menu.
2. Rotate the Course control knob to select [CSE AFTER REMOTE] then push the
knob.
3. Rotate the Course control knob to select desired option.
4. Push the Course control knob to finish.
4.4 Nav Data Source
Select the source of nav data to use in the NAV mode.
1. Select [OTHER MENU] followed by [NAV OPTION].
2. Rotate the Course control knob to select [NAV DATA SOURCE] then push the
knob.
3. Rotate the Course control knob to select [DATA SOURCE] then push the knob.
4. Rotate the Course control knob to select source then push the knob. If you have
more than one source of nav data, you can select [BOTH]. In this case, the nav
data fed by [SOURCE2] is used when that of [SOURCE1] is not available.
Previous course
New course
Remote
controller: OFF
Remote
controller: ON
PRESENT COURSE mode
Remote
controller: ON
Remote
controller: OFF
Previous course
PREVIOUS COURSE mode
PRESENT COURSE
PREVIOUS COURSE
NAV DATA SOURCE
DATA SOURCE: SOURCE1
SOURCE1: - - - - - - - - - - - - - -
SOURCE2: - - - - - - - - - - - - - -
SOURCE1
SOURCE2
BOTH
To Next Page
Loading...
