1. INSTALLATION
1-4
3. Secure the unit to the platform with four sets of M10 hex. nuts, spring washers and
flat washers (all included as installation materials) with 20 ±2 Nm torque.
Note 1: Take care not to crush the cabling when mounting the antenna to the plat-
form.
Note 2: Take care not to cover the breathing hole on the antenna.
4. Coat the exposed parts of the nuts, bolts and washers with the Adhesive TB5211
(included) to prevent corrosion.
5. Connect the SC-703 cable to the cable from the SC-701, then waterproof the con-
nection (see section 1.5.2 for the waterproofing procedure).
6. Remove the double-sided tape from the optional bird-repellent fixtures, then at-
tach to the antenna cover. Coat around the bird-repellent fixtures with the Adhe-
sive TB5211 (included).
7. Secure the cables to the mast (or superstructure) with cable ties, at regular inter-
vals.
BOW
200
300
160
Flat washer
5 mm to 15 mm
Spring washer
Hexagonal nut (M10)
Fixing hole (ø11 mm)
160
Positioning the antenna cable
(Stern view)
IndentIndent
CableCable
Mounting platform
Hex nuts
Bolt
Spring washer
Flat washer
Coat with adhesive.
Antenna baseAntenna base
To Next Page
Loading...
