Furuno SC-70 - How to Set the Display Language; GNSS Menu; How to Select the Positioning System to Use

2. OPERATION
2-23
How to enable/disable summer time
You can manually adjust the time to reflect summer (daylight saving) time.
1. Open the [DISPLAY] menu.
2. Select [TIME], then press the ENT key.
3. Select [SUMMER TIME], then press the ENT key.
4. Select [ON] to enable summer time, [OFF] to disable summer time.
5. Close the [MENU].
2.13.8 How to Set the Display Language
The SC-70/SC-130 can display menus and data in English or Japanese. If the display
language has been changed to Japanese, do the following to change the language
back to English.
Note: This procedure uses the menu item numbers which are displayed at the left-side
of each menu.
1. Open the [MENU].
2. Select [1], then press the ENT key.
3. Select [8], then press the ENT key.
4. Select [ENGLISH], then press the ENT key.
5. Close the [MENU].
2.14 GNSS Menu
You can adjust various GNSS-relat-
ed settings from the [GNSS] menu.
Press the MENU ESC key, select
[GNSS], then press the ENT key to
show the [GNSS] menu.
2.14.1 How to select the positioning system to use
1. Open the [GNSS] menu.
2. Select [POSN. SYSTEM], then press the ENT key.
3. Select the appropriate positioning system, then press the ENT key.
Note: At the time of printing, only [GPS] is available for selection. Other position-
ing system may be added at a later date.
4. Close the [MENU].