Furuno SC-70 - OPERATION; Controls and Menu Navigation

2-1
2. OPERATION
2.1 Controls Overview
No. Key Description
1 BRILL • Opens the [BRILL SETTING] window.
• With the BRILL SETTING window open, adjusts the screen brilliance.
2 DISP • With the menu open
: Close the menu and return to the last used display
mode’s main screen.
• Without the menu open
: Change the display mode.
3 MENU ESC • Open the main menu.
• Close the menu and return to the last used screen.
• Close settings pop up window and return to the last used menu.
4 ACK • Acknowledge an individual alert and close the alert pop up message.
5 LIST • Show the [LIST] display.
• Cycle through the [LIST] display.
6 ENT • Open a menu item.
• Confirm selected setting in pop up window.
• Switch between graphic and main display for the current device mode.
• From the SPD main screen: Long press to reset track (for non-IMO types
only).
7 Cursorpad • Navigate menus.
W button: Go back one layer in the menu.
X button: Open the selected menu item.
S button: Move selection cursor to the item above the current selection.
T button: Move selection cursor to the item below the current selection.
• Adjust settings.
W button: Move cursor to the left.
X button: Move cursor to the right.
S button: Increase the value of the selected item.
T button: Decrease the value of the selected item.
• With [INTEGRITY] screen shown: scroll through the displayed data when
more than one screen is available.
ACK
BRILL DISP
MENU
ESC
LIST ENT
1 2 3
4
7
5 6
24º40.1234’N
104º45.5678’E
GP-D3D CAUTION
TOKYO
567/199m
05 : 16 ’ 35 21 / DEC / 15 14 : 16 ’ 35 21 / DEC / 15
9 . 6
059
.1
6
.2