Furuno SC-70 - How to Set Geodetic Data; How to Reset the Trip Meter; How to Adjust the Date and Time

2. OPERATION
2-22
2.13.5 How to Set Geodetic Data
The SC-70/SC-130 uses the WGS84 datum as the default geodetic datum. To change
the datum used, follow the procedure below.
1. Open the [DISPLAY] menu.
2. Select [DATUM], then press the ENT key.
3. Select the appropriate datum, then press the ENT key. The available selections
are: [WGS84], [WGS72], [PZ90], [CK42], [CK95] and [OTHERS].
If the datum you wish to use is not displayed, select [OTHERS].
4. If you selected [OTHERS], proceed to step 5. For all other selections, close the
menu.
5. Input the chart number, referring to the geodetic chart list at the back of this man-
ual, then press the ENT key.
6. Close the [MENU].
2.13.6 How to Reset the Trip Meter
The trip meter calculates the distance your vessel has traveled and can be restarted
at any time. This menu is not available for IMO types.
To reset the trip meter, do the following:
1. Open the [DISPLAY] menu.
2. Select [TRIP SETTING], then press the ENT key.
3. [CLEAR] is already selected. Press the ENT key to reset the meter.
4. Close the [MENU].
2.13.7 How to Adjust the Date and Time
The SC-70/SC-130 can display the date and time in UTC format or as the local (geo-
graphical) time. You can also set for summer time. To adjust time settings, refer to the
appropriate topic below.
How to change the time display format
1. Open the [DISPLAY] menu.
2. Select [TIME], then press the ENT key.
3. Select [LOCAL TIME], then press the ENT key.
4. Select [UTC] or [LOCAL] as appropriate, then press the ENT key.
5. Close the [MENU].
Setting Remarks
[UTC] UTC (Coordinated Universal Time) time is calculated automatically.
[LOCAL] Manually input the time offset (based on UTC time).