2. WIRING
2-3
2.1.1 NETWORK port(s)
TZT9/14 (just like previous NavNets)
uses standard TCP/IP Ethernet to
share radar/sounder images and
other navigation information from de-
vices connected within the network system. In any single NavNet TZtouch network, a
combination of up to six TZT9/14 may be connected to each other. All NavNet TZ-
touch network components have integrated regular RJ45 Ethernet port(s), one on
TZT9 and three on TZT14. Connect MOD-WPAS0001-030+ cable (supplied).
2.1.2 MULTI port
Use the cable assembly FRUDD-
18AFFM-L180 (supplied, 2 m) for the
event switch, external buzzer, speed
alarm and the power for CAN bus.
This cable has an 18-pin connector. For example, a MOB contact closure input may
be connected to pin 15 and 11*.
*Note that any TZT9/14 interfaces to virtually any MOB system or event switch (point
save) contact closure signal using these pins.
Pin No. Color Function Remark (Port No.)
18 Light green NET-C IN (0V) CAN bus Power IN. When 12V DC power is
applied to these pins, the CAN bus port will
be powered (up to 1 ampere).
17 Pink NET-S IN (+12V IN)
16 Purple Shield
15 White BUZZER or EVENT IN
External Buzzer Output or MOB/Event Input
(Contact Closure)
14 Gray SPEED-ALARM C Speed alarm contact. Can trigger an exter-
nal alarm or device when speed exceeds
the limit specified.
13 Yellow SPEED-ALARM H
12 Black/White +12V External buzzer power ONLY (100mA Max)
11 Black GND GND for Event/MOB Input
10 Blue/White - For debug
9Blue -
8 Green/White -
7 Green -
6 Orange/White -
5 Orange GND
4 Brown/White DC_N
3 Brown PWR_SW
2 Red/White GND
1Red GND
TZT9
TZT14
TZT9
TZT14
7
12
16
17
13
8
3
1
4
9
14
18
15
10
5
2
6
11
To Next Page
Loading...
