Furuno TZT14 - Flush Mounting

1. MOUNTING
1-2
1.2 Flush Mounting
Select a flat mounting location and install the unit as shown below.
1. Prepare a cutout in the mounting location using the template (supplied) for the
TZT9 or TZT14.
2. Attach the flush mounting sponge (supplied as installation materials) to the back
of the TZT9/14.
3. Screw the wing bolts and the wing nuts of the flush mount fixture so that the pro-
tector for screw moves to the flush mount fixture.
4. Connect all cables at the back of the TZT9/14. (See chapter 2.)
Flush mounting sponge
Flush mount fixture
Flush mount fixture
Wing bolt
Protector for
screw
Move to the fixture.
Wing nut
Flush mount fixture