Furuno TZT14 - Example Navnet Tztouch System Configurations

2. WIRING
2-11
2.3 Example NavNet TZtouch System
Configurations
Basic plotter/fish finder installation
The FURUNO GP-330B is connected to the CAN bus backbone cable, using the op-
tional NMEA data converter IF-NMEA2K2 (or IF-NMEA2K1). The DFF series network
sounder is directly connected to the LAN port of the TZT using the standard supply
cable (3 m).
22. 129026 COG & SOG, Rapid Up-
date
250
23. 129029 GNSS Position Data 1000
24. 129033 Time & Date 1000
25. 129283 Cross Track Error 1000
26. 129284 Navigation Data 1000
27. 129285 Navigation-Route/WP In-
formation
• Outputs when waypoint is set/changed (own ship’s
position is required)
• Outputs when receiving ISO request
28. 130306 Wind Data 100
29. 130310 Environmental Parame-
ters
500
31. 130312 Temperature 2000
32. 130313 Humidity Outputs when receiving the ISO request
33. 130314 Actual Pressure 2000
No. PGN Description Remarks Output cycle (msec)
Network
Sounder
DFF3
Low
Freq.
Transducer
High
Freq.
DFF3
NETWORK SOUNDER
ST-BY
NMEA DATA CONVERTER
IF-NMEA2K2
GPS RECEIVER
GP-330B
MULTI FUNCTION DISPLAY
TZT9/14
LAN cable
(supplied, MOD-WPAS0001-030+)
3 m
*
*Cable fabrication is necessary to connect
GP-330B and IF-NMEA2K2.
12 VDC
CAN bus backbone cable
CAN bus
drop cable
Cable from
GP-330B
Cable from
IF-NMEA2K2
12-24 VDC
12/24 VDC
Joint Box
TL-CAT-012
LAN cable
(MOD-Z072)