Furuno TZT14 - How to Set up the Radar

3. SETTING UP THE EQUIPMENT
3-8
3.3 How to Set up the Radar
If you have a radar sensor, set the sensor’s characteristics on the [Radar] menu. Open
the [Menu Radar] sub menus. Drag the main menu to select [Radar].
1. Select [Radar Source] on the [Menu Radar] sub menus, then select the radar type
connected.
Note: If a DRS sensor is connected but does not appear in the [Radar Source] list,
close the list and open it again. The name of the DRS sensor should appear with
a check mark, as in the example below.
2. Drag the [Menu Radar] sub menus to find the menu item [Radar Initial Setup].
Title