Furuno TZT14 - Page 29

3. SETTING UP THE EQUIPMENT
3-7
Menu Initial Setup (SC-30 Setup)
Menu Initial Setup (Calibration)
Menu Initial Setup (Data Damping)
Menu Initial Setup (Browser Installation)
Note: The [External Touch Screen Mode] allows you to facilitate the operation of the
TZT9/TZT14 when an external dual touch screen is connected to the MFD via the USB
and DVI-D ports. When the [External Touch Screen Mode] is set to [ON], the contex-
tual Rotokeys appear near the cursor and the dual gesture is set automatically to dis-
play the “Home” screen.
[Data Source] Select the source for each data to input to the system. If two or more
sources are connected for a data, select one using the pull-down dialog
box. The Furuno products are shown at the upper part of the list.
[Sensor List] Show the information for sensors connected to your equipment. Also,
you can set “Nickname” for them here.
[PGN Output] Select [ON] for the PGNs (Parameter Group Number, CAN bus
(NMEA2000) message) to output from the CAN bus port.
[Sky View] Show the condition of GPS and GEO (WAAS) satellites. Number, bear-
ing and elevation angle of all GPS and GEO satellites (if applicable) in
view of your receiver appear.
Menu item Description Options (setting range)
[WAAS Mode] Select [ON] to use the WAAS mode.
[Heading Offset] Enter the offset value for heading. -180° to +180°
[Pitch Offset] Enter the offset value for pitching. -180° to +180°
[Roll Offset] Enter the offset value for rolling. -180° to +180°
Menu item Description Options (setting range)
[Heading] Offset heading data. -180.0° to +180.0°
[Speed Through
Water]
Calibrate speed data. Enter amount in percentage. -50% to +50%
[Wind Speed] Offset wind speed data. Enter amount in percentage. -50% to 50%
[Wind Angle] Offset wind angle data. -180° to +180°
[Sea Surface
Temperature]
Offset sea surface temperature data. -10°C to +10 °C
Menu item Description Options (setting range)
[COG & SOG] Set data damping time. The lower the set-
ting the faster the response to change.
0 to 59 seconds
[Heading]
[Speed Through Water]
[Wind Speed & Angle]
[Rate of Turn]
Menu item Description Option (setting range)
[FAX30 Browser] Show the Facsimile Receiver FAX-30 display.
[FA30 Browser] Show the AIS Receiver FA-30 display.
[FA50 Browser] Show the AIS Receiver FA-50 display.
Menu Item Description Options (setting range)