Furuno TZT14 - Page 28

3. SETTING UP THE EQUIPMENT
3-6
Menu Initial Setup (Engine)
Menu Initial Setup (Fuel)
Manu Initial Setup (Use Fuel Tank for calculations)
Menu Initial Setup (Data Acquisition)
[Transducer Draft
Source]
Select the draft source to use on the dis-
play, among the following:
Automatic: Use the offset value in the
DPT sentence. If the DPT sentence
does not have an offset value, the value
entered at Transducer Draft (page 3-11)
is used.
Hardware: Use the offset value in the
DPT sentence from an echosounder.
Manual: Use the value entered at
Transducer Draft (page 3-11).
[Automatic], [Hardware], [Man-
ual]
[Keel Draft] Set the keel draft. 0.0 to 99 ft
[Average Boat Speed] Select your boat type to use for average
speed calculation.
[Sailing], [Commercial], [Pow-
erboat]
[Nav Data Maximum
Depth]
Select the maximum depth for naviga-
tion data.
[Very Shallow] (under 10 m),
[Shallow] (10 to 20 m), [Deep]
(20 to 200 m), [Very Deep] (200
to 2000 m)
Menu Item Description Options (setting range)
[Number of Engine] Select the number of engines on your
boat.
[1], [2], [3], [4]
[Max. RPM] Set the maximum rpm of your engine to
show on the RPM display.
1000 to 20,000 rpm
[Red Zone RPM] Set the starting value for the red zone area
of the tachometer.
0 to 20,000 rpm
[Red Zone Oil Pressure] Set the starting value for the red zone area
of the oil pressure meter.
0 to 999 kPa
[Red Zone Temperature] Set the starting value for the red zone area
of the engine temperature indicator.
0°F to 999°F
[NickName Engine 1 to 4] Change the nickname for engine 1 to 4.
Menu Item Description Options (setting range)
[Number of Tank] Select the number of fuel tanks on your
boat.
[1], [2], [3], [4]
[NickName Tank 1 to 4] Change the nickname for fuel tank 1 to 4.
Menu Item Description Options (setting range)
[Tank 1 to 4] Select the tanks to calculate the fuel consumption. [ON], [OFF]
Menu Item Description Options (setting range)
[GP330B WAAS Mode] Select [ON] to use the WAAS mode for the
corresponding GPS antenna.
[ON], [OFF]
[WS200 WAAS Mode]
Menu item Description Options (setting range)