Furuno TZT14 - Page 34

3. SETTING UP THE EQUIPMENT
3-12
Motion sensor setting up
When you tap the [Transducer Setup], the [Motion Sensor] sub menus are shown be-
neath the [Transducer Setup] sub menus. If the satellite compass SC-30 or SC50/110
is connected, set the distance between the antenna unit (or sensor) of the satellite
compass and transducer (high and low if connected) here.
• Motion Sensor Type: Select [SC30] or [SC50-SC110] depending on the sensor
connected.
• Motion Sensor Antenna Position Bow/Stern HF (LF): Set the distance from the
antenna unit to the transducer in the bow-stern direction. If the transducer is located
on the fore side, set a positive value.
• Motion Sensor Antenna Position Up/Down HF (LF): Set the distance from the
transducer to the antenna unit in the vertical direction.
• Motion Sensor Antenna Port/Starboard HF (LF): Set the distance from the an-
tenna unit to the transducer in the port-starboard direction. If the transducer is locat-
ed on the starboard side, set a positive value.
SC-30/50/110
Up/Down
Up/Down
Bow/Stern for HF
Bow/Stern for HF
Bow/Stern for LF
Bow/Stern for LF
Port/Starboard for HF
Port/Starboard for HF
Port/Starboard for LF
Port/Starboard for LF
High
High
Low
Low