Furuno TZT2BB - Page 180

6. RADAR
6-29
[Auto Tuning]: Activate or deactivate auto tuning for the connected radar. Not avail-
able (grayed out) with the radar sensor DRS4D-NXT
[Tuning Source]: For dual range display, select the range to use as the manual tuning
source. Not available (grayed out) with the radar sensor DRS4DL/DRS4DL+, DRS4D-
NXT.
[Manual Tuning]: Manually tune. Not available (grayed out) with the radar sensor
DRS4D-NXT.
[Radar Monitoring]: Show various voltage levels, and ARPA data. For the service
technician.
[Radar Optimization]: Automatically adjust magnetron output and tuning for the con-
nected radar. Be sure to do this function after replacing the magnetron. Not avail-
able (grayed out) with the radar sensor DRS4D-NXT.
[ARPA Advanced Settings]: Sets ARPA parameters. For the service technician only.
Do not change the settings. Set [TX/STBY] to [ON] to access. Not available (grayed
out) with the radar sensor DRS4DL, FAR-2xx7 series radar antenna.
[Set Hardware to Factory Default]: For the service technician only.
[Reset Default Settings]: Restore default settings for items other than those in the
[RADAR INITIAL SETUP] section.