Furuno TZT2BB - How to Adjust the Transparency of the Data Area

1. SYSTEM INTRODUCTION
1-24
1.10.6 How to adjust the transparency of the data area
You can adjust the degree of transparency for the data box with [NavData Transpar-
ency] in the [Settings] - [Chart Plotter] menu. The available degree of transparency is
0 - 80(%).
Note: Alpha blending technology is used for transparency effects.
1.10.7 How to use the data box as a display for the SC-33
When a SC-33 Satellite Compass
™
is connected to the same network, you can use a
box in the data area as a dedicated SC-33 display.
Note: This function requires PGN 130578 Vessel Speed Components to be output
from the SC-33.
Referring to section 1.10.2 and section 1.10.3, select the 3-Axis Speed display.
The uppermost speed indication is the speed at the CCRP. The CCRP is set and
installation.
The middle speed indication is the speed at mid-ship.
The lowermost speed indication is the speed at the stern
Note 1: To correctly display directional indications and speed indications, the follow-
ing are required:
• Heading: when a valid heading is not input, wind and tidal current indications are
not shown. Further, speed is indicated as blank “----” and the compass directions
(N,S,E,W) are not shown.
• Connection to a rate gyro or gyrocompass: when there is no signal received from
the rate gyro or gyrocompass, the aft speed is indicated as blank “----”.
: Indicates speed in the fore/aft direction.
The directional indicators show which direction the boat is travelling.
Directional indicators
Wind direction
(
purple arrow
)
Tidal current direction
(
brown arrow
)
: Indicates transverse (port/starboard) speed.
3-Axis speeds show the speed at the
CCRP, mid-ship and stern. The CCRP, set
at installation, is either the bow, transducer
location, or center of the vessel.