FUTABA 7CAP - Naming and Configuring Model Memories; Using the MODEL NAME Function; Default Model Naming Convention

MODEL NAME: assigns a name to the current model memory. By giving each model a name that is immediately
recognizable, you can easily comfirm the correct model, and minimize the chance of flying the wrong model memory which
could lead to a crash.
Adjustability and values:
•
Up to 6 characters long.
•
Each character may be a letter, number, blank, or a symbol.
•
The default names assigned by the factory are in MDL-xx format (MDL-01 for
first model memory, etc.)
NOTE:Whenyou COPY one model memory over another, everything is copied, including the model's name. Similarly, if you
change MODEL TYPE or do a MODEL RESET,the entire memory is reset, including MODEL NAME. So the first thing you will want
to do after you COPY a model, change its type, or start from scratch, is rename the new copy to avoid confusion.
GOAL of EXAMPLE: STEPS: INPUTS:
27
Name model 3 "CAP-01" (where
the underline represents a blank
space.)
Where next?
Open MODEL submenu.
Confirm you are currently using the
proper model memory. (Ex: 3)
Go to NAME and change the first
character. (Ex: M to C)
Choose the next character to change.
Repeat the prior steps to complete
naming the model.
Close.
for 1 second.
(If ADVANCE, again.)
to MODEL.
If SELECTdoes not indicate 3,
perform MODEL SELECT,p.25.
to C.
to A
Repeat.
Change the MODEL TYPE to helicopter: see p. 28.
Change the receiver modulation setting from PPM to PCM or vice versa: see p. 28.
Utilize servo REVERSE : see p. 31.
Adjust servo travel with END POINT :seep. 32.
Set up dual/triple rates and exponential (D/R,EXP): see p. 34.