FLAP-ELEV mixing (ACR O ):
FLAP-ELEV mixing is a pre-programmed linear mix. This mix makes the elevator
move whenever the flaps are moved. This mix is used to compensate for any
pitching created by the flap.
Adjustability:
Rate: -100% (full up elevator) to +100 (full down elevator), with a default of +50% (one-half of the elevator range is
achieved when the flaps are lowered to full range.)
Offset: offsets the elevator's center relative to the flaps.
GOAL of EXAMPLE: STEPS: INPUTS:
Activate FLAP-ELEV mixing. Adjust
elevator travel to 45%.
Where next?
Open the FLAP-ELEV function.
Activate the function.
Adjust the travels as needed.
(Ex: +45%)
Close menu.
for 1 second.
(If basic, again.)
to FLAP-ELEV.
to 45%.
To Next Page
Loading...
