FUTABA 7CAP - Gyro Setup Example (Heading-Hold;AVCS); Setting Up Heading-hold;AVCS Gyro; Adjusting Gyro Rates

Gain Example for AVCS/Heading-hold Gyros (GY)
GOAL of EXAMPLE: STEPS: INPUTS:
73
Set up a heading-hold/AVCS gyro with
heading-hold/AVCS setting in idle-up
1 and normal mode setting in
idle-up2 and normal.
Where next?
Open and activate the GYRO function.
Optional: change gyro type to
Heading-hold (GY).
Optional: change switch assignment.
Ex: select E.
Adjust gyro rates as needed. (Ex:
NORM to A80%, IDL1 to A70%, IDL2
to N70% as starting points.)
Close the function.
for 1 second.
(If basic, again.)
to GYRO.
to SW.
to E.
to A80%.
to A70%.
to N70%.
D/R,EXP: see p. 34.
to ON.
to GY.