EasyManua.ls Logo

FUTABA 7CAP - Glossary of Common Terms (Part 3); Glossary: Data Reset and Delta Peak Charger; Glossary: Dual Rates and Elevator Terms; Glossary: END POINT and Exponential Terms

FUTABA 7CAP
82 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Data reset: erase all data in a specific model. See RESET.
Delta peak charger: common name for a specialized charger designed and required to properly peak charge both NiMH
and NiCd batteries, actually called a Zero Delta V Peak Charger. See Battery Care and Charging.
Dial: transmitterís rotary control and button used in various ways during programming. . . . . . . . . . . . . . . . . . . . . . .11
Differential: uneven movement in each direction of a control surface. Usually used when discussing ailerons or when
describing an undesirable unevenness in movement of other controls. See Twin aileron servos.
Diode: an electronic device which only allows current to flow one direction. Used to protect radio against power surge
and reversed polarity during charging..............................................................14
Discharge: to deplete the electrical energy in a battery pack, usually to its lowest safe voltage, for storage or as a part of
regular maintenance. See Battery care and charging.
Dual aileron servos: (ACRO )amodel using 2 servos on 2 separate channels to operate ailerons. May include
flaperon action. See Twin aileron servos..........................................43
Dual elevator servos: (ACRO )amodel using 2 servos on 2 separate channels to operate elevators. Includes elevon,
V-tail.
Dual rates (D/R,EXP): reduce/increase the servo travel by flipping a switch (or by stick position). Used to make model
more comfortable to fly in different maneuvers. 7C supports triple rates by simply assigning dual rates to 3 position
switches. Includes exponential function, see EXP.....................................................34
Elapsed Time Counter reset: see TIMER. ...........................................................37
Elevator: surface which controls the modelís rate of climb or descent. Also called cyclic pitch on helicopters.
Elevator-to-flap mix: (ACRO ) Used to apply flaps along with elevators to increase lift, allowing modeler to fly at
slower speeds, make tighter loops or turns, etc.
76
Elevator-to-pitch mix: (HELI) used to adjust pitch to counter the loss of angle of attack when elevator input is given. Not
a preprogrammed mix. See Programmable mix. .
ELEVON: flying wing configuration with 2 servos working together to create both aileron and elevator action.
......45
Elevons: two surfaces, one on each wing, which work as both ailerons and elevators. See ELEVON.
E
ND BUTTON:control button used during programming to return to previous menu or close menu altogether.
END POINT: often abbreviated EPA. Adjusts the total travel in each direction of proportional servos regardless of their control
assignment. Ex: adjustment to AIL channel will adjust only the servo plugged into channel 1 even if being used as one of two
flaperons or elevons. Note: End point is not an absolute; mixing can still drive the servo farther than this setting. . . . . . . . . . .32
Engine cut: see THR-CUT.
EPA: see END POINT.
Error messages: warnings/cautions provided by the radio when potential problems may exist. . . . . . . . . . . . . . . . . . .19
Exponential (D/R,EXP): adjustment to the relationship of STICK MOVEMENT to servo movement, typically used to soften
overly sensitive models around center. ............................................................34

Table of Contents

Related product manuals