SELECT (CURSOR) BUTTONS: controls used in various ways during programming. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11
Select a model: see MODEL SELECT.
Service Center. ...............................................................................3
Servo reversing: see REVERSE.
SET:toaccept. Usually done by pressing and holding the dial when instructed.
Slave: channel that moves in response to the command of the master. See Programmable mix.
Smoke system: injects a specialized smoke oil into the hot exhaust to create air-show like smoke trails. . . . . . . . . . . .56
SNAP ROLL:(ACRO) combines rudder, elevator and aileron movement to cause the aircraft to snap or spin at the flip of a
switch. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .47
Stick adjustments: change stick tension and height. ...................................................15
SUB-TRIM: used to fine tune the center or neutral point of each servo. Allows full trim function from the trim sliders for
flight trimming. ..............................................................................40
SWASH AFR:(HELI,CCPM types only) adjustment of the travel of all servos involved in the particular control's
movement only during the movement of that control. Ex: reverse the direction of movement of collective pitch while
not affecting the direction of movement of either cyclic control. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .63
Swashplate type: (HELI). Part of the model type selection process. Selects specific heli swashplate geometry, such as one
of four available types of "CCPM." ..............................................................61
Switch programmability: MANY features are reassignable to a variety of switches, including simply moving an
auxiliary control such as flaps from the stock dial to a switch or other location.
Synthesized receiver: The 7C is compatible with the R309DPS Futaba synthesized receiver that can be used on
any 72MHz channel.
...................................................................10
81
To Next Page
Loading...
