ADJUSTMENTS AND FLIGHT TECHNIQUES
•MODEL COPY FUNCTION
•The
Copy
function
allows
the
programmed data and
trim
positions
for
one model
to
be
duplicated
in
their entirety on another program (model) number. As an example, let's suppose that Aircraft No. 1 is
properly-trimmed and flys well, but you wish to experiment with a different mixing or trim setting. The
Model No. 1 data can be copied onto the Model No. 2 program. You can then make the experimental trim
modification on the Model No. 2 program only. The original settings will be retained as is, on the No. 1
program. The MODEL SELECT function can then be used to easily switch back and forth between the
old and new setting for comparison (although not in-flight).
•
As another
alternative,
settings
for
a
given
model
could
be
copied
on
two
or more programs
with
modifi-
cations for different weather conditions, maneuver schedules, etc.
Setting Method
1) Perform the Model Select function to select
the Model No. that you wish to copy.
2)
Move the cursor to the program
No. that you
wish
to copy the data onto, and press the
program key.
3) A message will appear asking if the data is to
be copied, (in the example shown, the Model
No. 1 data is to be copied to the Model No. 2
program slot.)
4) Press the key to execute the copy func-
key to cancel.
NOTE: Perform the TRIM MEMORY function
before copying. The trim levers can then be set
to the neutral position.
To Next Page
Loading...
