ADJUSTMENTS AND FLIGHT TECHNIQUES
SNAP ROLL
Snap rolls can be performed using the Snap Switch.
Four snap roll directions can be set: R/U (right up), R/D (right down), L/U (left up), and
L/D (left down)
snap.
The
snap
roll
direction
is
displayed
on the
screen.
The throw
of
each
servo (AIL, ELV, and RUD) is adjustable.
1. When the ENT (enter) key is
pressed, the throw of each stick
is
set.
Setting Method
1) Select the EDIT screen and move the cursor to Line 2 with the
cursor key, then press the MIX pro-
gram key.
2)
Press
the program key. The SNAP-ROLL
screen
will
be
displayed.
3) To activate the Snap Roll program, press the PROGRAM KEY. To inactivate the Snap Roll, press
the key.
4) Servo throw is set by pressing the program key.
a)
If the key
is
pressed
when the cursor
is
in the
"ACT/INH"
position,
all
rates
will
be
set
to
the
maximum AFR rate for each channel.
b) Rates can be set individually by moving the cursor to each rate position and using the ,or
program key. A good starting point is AIL - 110%, RUD - 50%, and ELV - 80%.
To Next Page
Loading...
