FUTABA FX-36 - Page 144

144
＜ Modelmenu(Airplane/Glider/MulticopterFunctions) ＞
Trimmix1/2
[Corresponding model type]: Glider, general
These functions call the ailerons, elevators, and
Àaps (camber Àaps, brake Àaps) trim offset rates
preset according to the Àight state.
The amount of ailerons, elevator, and flaps
(camber Àap, brake Àap) trim offset can be set to
a switch.
As an example Trim mix 1 can be set up for
launching, with speed Àaps and ailerons dropped,
and a slight amount of up elevator. Trim mix
2 can be used for high speed flying, with both
ailerons and speed Àaps reÀexed slightly, and a bit
of down elevator.
The trim functions can be activated during
Àight by setting a switch. To prevent sudden trim
changes when switching Àight conditions, a delay
can be set to provide a smooth transition between
the two. Trim mix 2 will have priority over Trim
mix 1.
Theoffsetrateofailerons,flapsandelevatorscanbeadjusted.
Taptothecorrespondingsettingitem.Adjusttherate.
Example
1. Move to the [INH] item
.
Set the trim mix function to
[ON].
*When separating the settings for each condition, move to
the [Group] item and set it to [Single].
2. Select the ON/OFF switch.
3. Select the [Manual] or [Auto] mode.
In the [Auto] mode, also select an auto SW. This
switch can be linked to a stick, etc.
Speed!
In: The operation speed at switch ON can be set.
Out: The return speed at switch OFF can be set.
Fine Tuning!
The offset rate can be varied in the Fine Tuning
numeric range set at screen by VR, etc. selection.
Condition Delay!
When Áight conditions are set, the operation speed
can be set for each condition. Condition delay
operation can be interrupted and each rudder
Tuickly returned to its original position by selecting a
cut switch.
ŏ Select [Trim mix1 or 2] at the model
menu and call the setup screen
shown below.
Whenusingthis
function,Tap[INH].
(ONisdisplayed.)
TheON/OFFswitchof
mixingischosen.
Manual/Automode
selection
Manual:Switchesthe
functionON/OFFby
switch
Auto:Trimmixfunction
callcanbelinkedtoa
stick,etc.Astickswitch,
etc.separatefromthe
functionON/OFFswitch
isset.
Conditiondelaysetting
Conditiondelay
cutswitch
Inspeed
Outspeed
（First）0〜27（Slowly）
*Thedisplayscreenisanexample.Theactual
screendependsontheModelType.
WhenafinetuningVRisset,
thetrimratesofailerons,
flapsandelevatorscanbe
adjusted.
Tonextpage
ŏReturn to Model menu
Thevalueinsidethe
parenthesesshowsthe
currentrudderposition.