FUTABA FX-36 - Camber Mixing

128
＜ Modelmenu(Airplane/Glider/MulticopterFunctions) ＞
AIL3
(ChipAileron)
AIL4
(ChipAileron)
AIL1
(MainAileron)
AIL2
(MainAileron)
FLP2
(CamberFlap)
FLP1
(CamberFlap)
ELEVATOR
(ELEVATOR2)
V-TAIL AILVATOR
FLP3
AIRBRAKE
(BrakeFlap)
FLP4
(BrakeFlap)
RUDDER2
Winglet
RUDDER1
RUDDER
(RUDDER2)
Winglet
atFlyingwing atFlyingwing
()
()
ELEVATOR
ELEVATOR2
(AILERON5)
(AILERON6)
Camber mixing
This mix adjusts the camber and corrects the
elevators. [Airplane/glider, 2 ailerons or more]
Airbrakeĺ ELE
This mix is used to correct operation of the airbrakes
(spoilers) when landing. [Airplane/glider, general]
Camber ÀapĺELE
This mix is used to correct for attitude changes when
the camber flaps are being used. [Airplane/glider, 2
ailerons + 1 Àap or more]
RudderĺAileron
This function is used to correct roll knife edge, etc.
of stunt planes. [Airplane/glider, general]
RudderĺElevator
This function is used to correct roll maneuvers, knife
edge, etc. of stunt planes. [Airplane, general]
ButterÀy (Crow)
This function is used when powerful brake operation
is necessary. [Glider, 2 ailerons or more]
Trim mix 1/2
The ailerons, elevators, and flaps trim offset rate
can be called by switch or condition selection. [Glider
general]
Snap roll
This function selects the snap roll switch and adjusts
the steering angle of each rudder. Servo speed can also
be adjusted. [Airplane general]
Air brake
This function is used when airbrakes are necessary
when landing or when diving, etc. during flight.
[Airplane, general]
Gyro
This is a dedicated mix when a GYA Series gyro is
used. [Airplane/glider/multicopter, general]
Ailevator
This function adjusts the elevators and ailerons of
models with elevator specifications. [Airplane/glider,
elevator speci¿cations]
Acceleration
Allows a brief "overload" in response to sudden
Elevator, ElevatorĺCamber, and AilĺRudder. [Glider
general]
Motor
The operation speed when the motor of F5B
and other EP gliders is started by switch can be set.
[Airplane/glider, general]
V-Tail
This function adjusts the elevators and rudder of
V-tail models. [Airplane/glider, V-tail speci¿cations]
Winglet
This function adjusts the left and right rudders of
winglet models. [Airplane/glider, winglet speci¿cations]