FUTABA FX-36 - U 2 I

35
＜ BeforeUse ＞
ŶőťŸŶŒŶőťŸŶŕŃŬƑƖƗƄƏƏƄƗƌƒƑ
This set uses the S.%8S/S.%8S2 system. The wiring is as simpli¿ed and clean mounting as possible
even with models that use a large number of servos. In addition the wings can be quickly installed to the
fuselage without any erroneous wiring by the use of only one simple wire even when there are a large
number of servos used.
Ɣ:hen using S.%8S/S.%8S2 special settings and mixes in your transmitter may be unnecessary.
ƔThe S.%8S/S.%8S2 servos memorize the number of channels themselves. settable with the FX-36
ƔThe S.%8S/S.%8S2 system and conventional system receiver conventional CH used can be mixed.
Receiver:R7008SB
Battery:FR2F1800(Optional)
Switch
Throttleservo:BLS173SV(Optional)
Aileronservo:BLS174SV×2(Optional)
Elevatorservo:BLS173SV×2(Optional)
RudderServo:BLS175SV×1(Optional)
HUB×3(Optional)

Receiver:R7008SB
Servo:S3174SV×9(Optional)
HUB×4(Optional)
S.BUS Gliderusageexample
S.BUSAerobaticplaneusageexample