FUTABA FX-36 - Range Check

59
＜ Systemmenu ＞
Battery
Low battery alarm voltage set
*When the low battery voltage setting is changed, it is changed for
every model in the transmitter. A unique voltage cannot be set for
each model. A change in the low battery voltage setting also does
not reset other data.
Select the battery alarm voltage according to the
battery to be used.
Batterytypechange:
LiFe(2cells) → NiMH(5cells)
→ Manualsetting
Itisn'tindicatedincase
ofmanualsetting.
VibratorTypes
Type1
Type2
Type3
Auto power off time setting
This function prevents battery
discharging if the transmitter power
supply does not erase.
1. Adjust the auto power off time with
the value input buttons.
*When the time the transmitter is inactive reaches
the set time, the power is turned off automatically.
This time can be set up to 1 hour in 10 minutes
increments. The auto power off function can also
be deactivated.
*An audible alarm is sounded from 3 minutes
before auto power off. When a stick or switch is
operated, the alarm is cleared.
RefertoP.43
RangeCheck
Before a Áight ground range check.
The 'range check mode' reduces the transmission
range of the radio waves to allow for a ground
range check.
*The range check mode, when activated, will continue for
90 seconds unless the user exits this mode early. When the
progress bar reaches 90 second mark, the RF transmission
automatically

returns to the normal operating power.
WARNING
Donotflyintherangecheck
mode.
*Sincetherangeoftheradiowavesis
short,ifthemodelistoofarfromthe
transmitter,controlwillbelostandthe
modelwillcrash.
ŏReturn to System menu
Whenchoosingmanual
setting,thenumerical
valuecanbeinput.
It'sdangerousto
setitmanuallyin
thelowvoltage.
Attention:

When using the 5-cell NiMH battery, the alarm setting is 5NiMH. If you
use a 2SLiFe battery, change the setting for the undervoltage warning to 2LiFe, if you
use a 2SLiPo battery, change the setting to manual setting 7,0V.