FUTABA FX-36 - Page 60

60
＜ Systemmenu ＞
S.B8S/S.B8S2
Servo
Procedure for changing S.BUS servo setting
1. Select [S.Bus servo] of the System menu.
2. Wire the servo as shown in the Àgure.
3. Press [Read]. The ID and current setting of
that servo are displayed.
S.Busservo
S.B8S servo setting
ŏ Call the following setting screen by pressing the
[S.Bus Servo] button in the System menu.
ƔServo ID number
If you use multiple S.BUS servos, only the desired
servo in the group can be set by entering the ID of
that speci¿c servo.
An S.BUS(2) servo can memorize the channel
and various settings you input. Servo setting can
be performed on the FX-36 screen by wiring the
servo as shown in the ¿gure.
* With some S.BUS(2) servos, there are some functions which
cannot be used. If a function cannot be used, the display
screen will change. (Only the function which can be used by
a servo is displayed.)
* After reading completion, with connection of the above
¿gure, if a stick is moved, servo operation can be tested.
SERVO SERVO
3-way hub
or Y-harnesses
SERVO SERVO SERVO
4. When multiple servos are connected change
[INH] at the right side of the ID number on the
screen to [ACT] and enter the ID of the servo
you want to set.
5. Set each item. (Please see the next page.)
6. Press [Write]. The settings are changed.
ŏReturn to System menu