FUTABA FX-36 - Page 75

75
＜ Linkagemenu ＞
TheMotorfunctionisusedwhenswitchingthe
motorON/OFF(mostlyformotorgliders).For
mostEPplanes,thethrottlecanbeleftas-iswhen
controllingthemotorbystick.Thismeansthatthe
variousthrottle-relatedfunctionsareusablevia
motorcontrol.
Tapthechannelyou
wishtoreverse.
Tapthe “Yes”
→ H/Wreverse
Trim change
1. Tap the trim button to call the trim setup
screen.
H/W reverse
2. The following items can be set at the trim
setup screen.
ŏ Hardware setting (Selection of switch, etc.
which controls trim)
ŏ Rate setting
ŏ Trim mode setting
Normal mode: Normal trim (linear) operation
ATL mode: ATL operation mode. (Works at only one
end of operation) Reverse is also possible.
Center mode: Maximum change near center by
center trim operation (Does not change at end of
the stick movement)
$
77
7 7
--
--
7 7
/' 5'
/6
6, 6-
56
%() &'*+
This function reverses the operation signal of the
sticks, switches, trim levers, and knobs.
Note: This setting reverses the actual operation
signal, but does not change the display of the
indicators on the display. Use the Normal mode as
long as there is no special reason to use the reverse
mode.