41
From 1/3
Go to 3/3 from any
cursor position
(6) S. BUS connection: Rot HD Gn channel
Using the [ /+] or [ /-] key to set the correct channel number.
(7) S. BUS connection: Gain RUD channel
Using the [ /+] or [ /-] key to set the correct channel number.
(8) S. BUS connection: GOV rpm channel
Using the [ /+] or [ /-] key to set the correct channel number.
(9) S. BUS connection: GOV sw channel
Using the [ /+] or [ /-] key to set the correct channel number.
(10) S. BUS connection:
Condition on change channel
Using the methodology described previously, deter-
mine the "Cond CH #" and use the [ /+] or [ /-] key to
set the condition change channel of the transmitter. In
this example, DG1 is the conditional change channel.
SBUS BASIC screen 2/3
As with the flight condition function of the transmitter, it is possible
to utilize pre-determined settings, each activated by a switch or
switches on the transmitter. By setting the condition switch on the
channel with the AFR function of the transmitter and setting the
point for each flight condition with the AFR point curve, you can
switch the condition of CGY760R/CGY755 in conjunction with the
flight condition switch of the transmitter.
If the "Setup Style" setting of the "SWH BASIC"
menu is "F3C", it is necessary to set the aile-
ron (Roll) gain and the elevator (Pitch) gain on
separate channels. (Gain AIL and Gain ELE
display)
F3C
3D
To Next Page
Loading...
Need help?
General
