FUTABA T10PX User Manual

HPS-CT701 has been added to the UR mode / SR compatible servos.
It corresponds to MC971CR. MC971CR is added to the selection screen of the MC (ESC)-Link function.
Instead of operating the [-] [+] buttons on the touch panel, you can change the value by trimming / dialing.
2. Compatible with HPS-CT701
3. Compatible with MC971CR
4. A function to change the data on the setting screen has
been added to the trim / dial function of the linkage menu.
Open the Trim / Dial Settings screen and select the trim / dial to assign to the operation to change the setting data.
From the list, select Rate.
Open the screen of the function to make adjustments, and touch and select the item for which you want
to change the setting data. The data will be changed by operating the trim / dial assigned earlier.
*If the item whose data you want to change is not selected and the
[-] [+] buttons are not displayed on the screen, the data will not be
changed even if you operate the trim / dial.
1
2
3
*[Important] "Torque level" and "Torque end point" function can operate only when
using ACUVANCE brushless motor "LUXON AGILE" and "FLEDGE".
When using a motor of ACUVANCE "LUXON BS" and "LUXON", or a motor of other
than ACUVANCE, setting isn't possible or it doesn't operate properly.

FUTABA T10PX Specifications

General

Channels	10
Frequency	2.4GHz
Telemetry	Yes
Modulation	T-FHSS, S-FHSS
Display	4.3-inch full-color LCD touch screen