6. Precautions and warnings
5.3. Depending upon the source and destination transmitter models, a warning dialog
might appear. Read the information in the dialog box prior to clicking the "OK"
button. Additionally, we suggest that you check the operation of the model prior to
flight.
1. Telemetry setting data are not converted by the converter.
2. The Box/Hysteresis setting of the hardware is canceled.
3. The nested logic switch is set to NULL.
4. All logic switches except the "Condition Select" are set to NULL.
5. The Linear/VTR/Spline curve is changed to a point curve.
6. The combination setting is set to Single mode unless it is set in all Condition to Group.
7. The setting of "Fuel Mixture" and "Multi Engine" are initialized.
Data Conversion from T18MZ Data
To Next Page
Loading...
